DEVELOPMENT OF TECHNOLOGY FOR MANUFACTURING MOLDING AND CORE MIXTURES FOR OBTAINING SYNTHETIC CAST IRON

Authors

  • Turakulov Murot Rustamovich Senior lecturer, of the Department of Materials Science and Mechanical Engineering, Tashkent State Transport University, Tashkent, The Republic of Uzbekistan
  • Tursunov Nodirjon Kayumjonovich Ph.D., head of the Department of Materials Science and Mechanical Engineering, Tashkent State Transport University, Tashkent, The Republic of Uzbekistan
  • Alimukhamedov Shavkat Pirmukhamedovich Dr. tech. sciences, professor of the Department of Materials Science and Mechanical Engineering, Tashkent State Transport University, Tashkent, The Republic of Uzbekistan
  • Toirov Otabek Toir ugli Ph.D. student of the Department of Materials Science and Mechanical Engineering, Tashkent State Transport University, Tashkent, The Republic of Uzbekistan
  • Kuchkorov Lochinbek Akhmadjon ugli Ph.D. student of the Department of Materials Science and Mechanical Engineering, Tashkent State Transport University, Tashkent, The Republic of Uzbekistan

DOI:

https://doi.org/10.17605/OSF.IO/UETWG

Keywords:

synthetic cast iron,, molding sand, core sand

Abstract

The article presents the technology for manufacturing molding and core sands for producing synthetic cast iron, and also describes the scheme of the molding - pouring line. The composition and properties of core mixtures are reflected. Shows the process of preparing the molding sand using a mixing runner.

Downloads

Published

2022-05-31

Issue

Vol. 3 No. 5 (2022): wos

Section

Articles

Most read articles by the same author(s)

1 2 3 > >>