IMPROVING THE TECHNOLOGY OF MANUFACTURING PARTS TO REDUCE COSTS

Authors

  • Valieva D.Sh. Assistant teacher of the Department of Materials Science and Mechanical Engineering, Tashkent State Transport University
  • Erkinov S.M. Assistant of Tashkent State Technical University named after Islam Karimov
  • Omonov I. Kh Samarkand State Institute of Architecture and Construction
  • Azimov S. Zh. Senior Lecturer of the Department of Materials Science and Mechanical Engineering, Tashkent State Transport University, Tashkent
  • Toirov O. T. Ph.D. student of the Department of Materials Science and Mechanical Engineering, Tashkent State Transport University, Tashkent

DOI:

https://doi.org/10.17605/OSF.IO/9TXKC

Keywords:

Control flange, pump – regulator, block – contactors

Abstract

This work is devoted to improving the technology of manufacturing parts in order to improve the quality of workmanship, a given productivity and low cost. This goal is achieved by developing a non-standard fixture that provides high accuracy and efficiency without changing the position of the part, which leads to an increase in productivity and a reduction in the machining cost for mass production.

Downloads

Published

2022-05-31

How to Cite

Valieva D.Sh., Erkinov S.M., Omonov I. Kh, Azimov S. Zh., & Toirov O. T. (2022). IMPROVING THE TECHNOLOGY OF MANUFACTURING PARTS TO REDUCE COSTS. Web of Scientist: International Scientific Research Journal, 3(5), 1834–1839. https://doi.org/10.17605/OSF.IO/9TXKC

Issue

Section

Articles