DEVELOPMENT PRODUCTION TECHNOLOGY ROLLER OF THE INTRODUCTORY BOX OF THE CRATE NO.23

Authors

  • Nurmurodov S. D. Professor, Materials Science Department, Tashkent State Technical University
  • Pardayeva G. T. Senior teacher, Materials Science Department, Tashkent State Technical University
  • Mukhtorov Sh. T Master student, Materials Science Department, Tashkent State Technical University

DOI:

https://doi.org/10.17605/OSF.IO/HUZDA

Keywords:

development, technology, roller

Abstract

The article deals with the deformation of hot metal, which is produced using rolls of a rolling stand. Rolling of metal to the finished profile is carried out by gradual settling and pulling of workpieces in roll calibers. The rolls operate at a temperature of 1100 °C with wear of the contact surfaces during operation. The wear of the rolls leads to deterioration of the surface quality of the finished rolled products. This leads to a deviation in the size of the workpiece of the product and from the specified technological regulations forced to replace the rolls with a stop of production.

Downloads

Published

2022-02-19

How to Cite

Nurmurodov S. D., Pardayeva G. T., & Mukhtorov Sh. T. (2022). DEVELOPMENT PRODUCTION TECHNOLOGY ROLLER OF THE INTRODUCTORY BOX OF THE CRATE NO.23. Web of Scientist: International Scientific Research Journal, 3(02), 514–523. https://doi.org/10.17605/OSF.IO/HUZDA

Issue

Vol. 3 No. 02 (2022): wos

Section

Articles