IMPROVEMENT OF THE PROCESS OF BLOWING METAL WITH ARGON IN A STEEL-POSING LADLE TO IMPROVE ITS QUALITY

Authors

  • Toirov Otabek Toir ugli Ph.D. student of the Department of Materials Science and Mechanical Engineering, Tashkent State Transport University, Tashkent, The Republic of Uzbekistan
  • Tursunov Nodirjon Kayumjonovich Ph.D., head of the Department of Materials Science and Mechanical Engineering, Tashkent State Transport University, Tashkent, The Republic of Uzbekistan
  • Axmedova Dilafruz Alovuddin qizi Assistant teacher of the Department of Materials Science and Mechanical Engineering, Tashkent State Transport University, Tashkent, The Republic of Uzbekistan

DOI:

https://doi.org/10.17605/OSF.IO/DKF6G

Keywords:

liquid steel, argon purge, mathematical modeling, purge block, homogenization.

Abstract

This article is devoted to out-of-furnace processing of liquid steel, namely, to purging metal with inert gases in order to improve its quality. The main advantages of purging with inert gases, the efficient arrangement of purging units, as well as the dependence of the time of homogenization of liquid steel on the volumetric flow rate of inert gas are considered.

Downloads

Published

2023-05-25

How to Cite

Toirov Otabek Toir ugli, Tursunov Nodirjon Kayumjonovich, & Axmedova Dilafruz Alovuddin qizi. (2023). IMPROVEMENT OF THE PROCESS OF BLOWING METAL WITH ARGON IN A STEEL-POSING LADLE TO IMPROVE ITS QUALITY. Web of Scientist: International Scientific Research Journal, 4(5), 793–798. https://doi.org/10.17605/OSF.IO/DKF6G

Issue

Vol. 4 No. 5 (2023): wos

Section

Articles

License

Copyright (c) 2023 Web of Scientist: International Scientific Research Journal

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

Most read articles by the same author(s)

<< < 1 2 3 > >>